Hyundai Tucson LM Quiz
Engine Control System/Fuel System

Fuel Tank Pressure Sensor (FTPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
7steps
~42min
2/5difficulty
Done 0 of 7

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the output voltage of the FTPS.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the rear seat. (Refer to Body - "Seat")
  3. Remove the fuel pump service cover (A).
  4. Disconnect the fuel tank pressure sensor connector (A).
  5. Remove the fuel tank pressure sensor by releasing the hooks in the vertical position.

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. In this case, inspect it before use.
  • Insert the sensor into the mounting hole, being careful not to damage it during installation.
  1. Install in the reverse order of removal.

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.