Hyundai Tucson LM Quiz
Engine Control System/Fuel System

Manifold Absolute Pressure (MAP) Sensor Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
5steps
~30min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the MAP sensor output voltage at idle and with the ignition ON.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the MAP sensor connector (A).
  3. Loosen the mounting bolt (B) and remove the sensor from the surge tank.

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. If the component has been dropped, inspect it before installation.
  • Insert the sensor into the installation hole, being careful not to damage it.
  1. Install in the reverse order of removal. MAP sensor mounting bolt: 9.8 ~ 11.8 N·m

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.