LED Front Fog Lamp

If your vehicle is equipped with LED fog lamps, they are replaced as an assembly.

Rear Tail, Stop, Turn Signal and Backup Lamp

Refer to the following steps for replacement:

1. 1
   Remove the trim panel plug to access the single fastener for the rear lamp assembly.

   

   Trim Cap

2. 2
   Remove the retaining screw, disconnect the electrical connector, then remove the rear lamp assembly from the vehicle.

   NOTE:

   If necessary, press the tab on the assembly located inside behind the lamp housing.

   

   Retaining Screw

3. 3
   Remove the three screws from the Bracket Assembly to access the bulb sockets.

   

   Mounting Bracket

4. 4
   Turn the applicable connector counterclockwise one-quarter turn, then remove it from the housing.
5. 5
   Pull the bulb straight out of the socket to replace it.

Center High-Mounted Stop Lamp (CHMSL)

The stop lamp is installed on the bracket that extends upward from the swing gate behind the spare tire. If service is required, obtain the LED Assembly from an authorized dealer.

Refer to the following steps for replacement:

1. 1
   Remove the spare tire.
2. 2
   Remove the screws securing the tire carrier cover.
3. 3
   Remove the two screws from the lamp assembly and disconnect the electrical connector.

License Plate Lamps

Contact an authorized dealer to replace the LED lamps.

NOTE:

To install the new bulb, reverse the removal procedure. When installing the new bulb, take care to avoid touching the bulb glass with bare skin.