Bulb Replacement

NOTE:

Refer to an authorized dealer for LED lamp replacement.

NOTE:

Lens fogging may occur under certain atmospheric conditions. This is normally cleared as atmospheric conditions change, allowing the condensation to turn back into vapor. Turning on the lamps normally speeds up the clearing process.

Halogen Headlamps

Refer to the following steps for replacement:

1. 1
   Open the hood and support it with the hood prop rod.
2. 2
   Remove the front grille. Turn the fasteners at the top one-quarter turn counterclockwise and remove.
3. 3
   Pull the bottom of the grille outward, starting at one side and working toward the other.
4. 4
   Remove the three screws securing the headlamp to the vehicle.
5. 5
   Remove the lamp from the vehicle.
6. 6
   Remove the lamp from the collar.
7. 7
   Grasp the bulb and turn one-quarter turn counterclockwise.
8. 8
   Pull the bulb out of the housing.
9. 9
   Press the connector lock tab to unlock it.
10. 10
    Disconnect the connector from the lamp.
11. 11
    Insert the connector into the base of the new lamp and press the connector lock tab until it is fully seated.
12. 12
    Install the lamp housing in place. Turn the bulb one-quarter turn clockwise.

Front Parking/Turn Signal

Refer to the following steps for replacement:

1. 1
   Remove the front wheel arch liner fasteners to access the lamp sockets.

   

   Wheel Liner

2. 2
   Turn the socket assembly one-quarter turn counterclockwise and remove it from the housing. Pull the bulb straight out of the socket for replacement.

LED Front Side Marker

Refer to the following steps for replacement:

1. 1
   Remove the front wheel arch liner fasteners to access the screw and electrical connector.
2. 2
   Remove the fastener screw at the rear of the assembly and disconnect the front side marker electrical connector.
3. 3
   Remove and replace the LED front side marker lamp assembly.

Halogen Front Fog Lamp

Refer to the following steps for replacement:

1. 1
   Reach under the vehicle to access the rear of the front fog lamp.
2. 2
   Disconnect the wire harness connector from the front fog lamp socket.
3. 3
   Firmly grasp the lamp by its two retaining tabs and squeeze them together to release the bulb from the rear of the front fog lamp housing.
4. 4
   Pull the bulb straight out of the keyed opening in the housing, then connect the replacement bulb.