Kia Forte BD Quiz
Body Electrical System

Ignition Lock Assembly

In this manual: Body Electrical System
General Information — 8Maintenance — 32Engine Mechanical System — 47Engine Electrical System — 17Emission Control System — 10Engine Control System/Fuel System — 32Clutch System — 11Manual Transmission — 11DCT (Dual Clutch Transmission) System — 16Drive Shaft and Axle — 8Suspension System — 26Steering — 9Restraints — 11Brake System — 27Body (Interior and Exterior) — 119Body Electrical System — 98Heating, Ventilation, and Air Conditioning — 27
7steps
~42min
2/5difficulty
Done 0 of 7

Repair Procedures

Removal

  1. Disconnect the negative (-) battery terminal.

  2. Remove the airbag lower panel.

    (Refer to Body - "Under Cover Panel")

  3. Remove the upper and lower steering column covers.

    (Refer to Body - "Steering Column Shroud Panel")

  4. Remove the ignition switch (A) by loosening the screws after disconnecting the connector.

Installation

  1. Install in the reverse order of removal.

Inspection

  1. Disconnect the ignition switch connector (A) and the key warning switch connector (B) from under the steering column.

  2. Check the circuit between the terminals for continuity.

  3. If continuity is not as specified, replace the switch.

Test yourself

A quick Kia Forte BD quiz: every answer comes with an explanation and a link to the manual page.