Kia Optima DL3 Quiz
Body Electrical System

Audio/Video Navigation

In this manual: Body Electrical System
General Information — 8Advanced Driver Assistance System (ADAS) — 21Maintenance — 27Engine Mechanical System — 45Engine Electrical System — 11Emission Control System — 11Engine Control System/Fuel System — 25Automatic Transmission — 20Drive Shaft and Axle — 7Suspension System — 22Steering — 7Restraints — 11Brake System — 22Body (Interior and Exterior) — 116Body Electrical System — 90Heating, Ventilation, and Air Conditioning — 32
3steps
~18min
2/5difficulty
Done 0 of 3

Components and Component Location

Components

1. AVN Head Unit

Circuit Diagrams

Connector and Terminal Function

AVN 5.0

[Type]

[Type B]

Pin Function
Connector A Connector B
External amplifier Internal Amplifier
1 - Rear Left Door Speaker (+) -
2 - Rear Left Door Speaker (-) MIC1 (+)
3 Voice navigation amplifier (+) - -
4 Amplifier_SPDIF (High) - -
5 - -
6 CVBS type: Camera power / LVDS type: - Illumination (+)
7 CVBS type: Camera video / LVDS type: - MM-CAN (High)
8 - -
9 - -
10 - Battery (+)
11 - (USB Detection) Battery (+)
12 Steering Wheel Remote Control Key Ground
13 - Front Left Door Speaker (+) Ground
14 - Left Front Door Speaker (-) -
15 - Right Front Door Speaker (-) MIC1 (-)
16 - Front Right Door Speaker (+) -
17 Voice navigation amplifier (-) - -
18 Amplifier SPDIF (Low) - -
19 SPDIF Amplifier (Ground) - Illumination (-)
20 CVBS type: Camera ground / LVDS type: - MM-CAN (Low)
21 CVBS type: Camera video ground / LVDS type: - -
22 - ACC
23 - -
24 - -
25 - -
26 Steering Wheel Key Ground -
27 - Right Rear Door Speaker (-) -
28 - Rear Right Door Speaker (+) -
29 - -
30 - -
31 - -
32 RVM: - / SVM: Ground -
33 CVBS type: Camera screen ground / LVDS type: - IGN1
34 - -
35 - -
36 -
37 -
38 Vehicle Speed

Repair Procedures

Removal

  1. Disconnect the negative battery cable.

  2. Remove the decorative trim [RH].

    (Refer to Body — Crash Pad Garnish)

  3. Remove the AVN head unit.

    1. Remove the upper panel of the center fascia (A) using a screwdriver or remover.

    2. Remove the AVN head unit (A) after loosening the mounting screws.

    3. Disconnect all connectors (A) from the AVN head unit.

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Optima DL3 quiz: every answer comes with an explanation and a link to the manual page.