Drive Belt

Repair Procedures

Inspection

1. 1

   Inspect the belt for wear and abnormal wear of the ribbed portion. Replace if necessary.

2. 2

   Visually inspect the belt for excessive wear, frayed cords, etc.

   If any defect is found, replace the drive belt.

   

Removal and Installation

1. 1

   Remove the engine room cover.

   (Refer to Engine Mechanical System - "Engine Room Cover")

2. 2

   Remove the drive belt.

   [Kappa 1.0 T-GDI]

   1. To release the tension, turn the drive belt tensioner (A) clockwise. Then remove the drive belt (B).

      

      

   [Kappa 1.2 MPa, 1.4 MPa]

   1. Using a wrench, turn the automatic tensioner pulley (A) counterclockwise, then insert the stopper pin (B) into the hole.

      

   2. Remove the drive belt (A).

      

   [U-2 1.4 CRDi]

   1. Using a hex key, turn the tensioner (A) counterclockwise and loosen it. Then remove the drive belt (B).

      

3. 3

   Install in the reverse order of removal.