Engine

Additional Service When Replacing Ecm

10steps
~60min
3/5difficulty
Done 0 of 10

Description

When replacing ECM, the following procedure must be performed. (For details, refer to Work Procedure.)

PROGRAMMING OPERATION

Work Procedure

Work Procedure (Before Replacing ECM)

SAVE ECM DATA

With CONSULT

  1. Ignition switch OFF.

  2. Reconnect all harness connectors disconnected.

  3. Ignition switch ON.

  4. Select “Replace ECU” of “ECM” using CONSULT.

  5. Follow the instruction of CONSULT display.

>>
  • Replace ECM.

  • After replacing ECM, perform necessary work.

Work Procedure (After Replacing ECM)

WRITING VEHICLE SPECIFICATION

With CONSULT

Write vehicle specification to ECM according to "Replace ECU" in CONSULT Operation Manual.

  • Ignition switch: ON

  • Electric load: OFF

  • Brake pedal: Not depressed

  • Battery voltage: 12 – 13.5 V (Check the value displayed on the CONSULT screen.)

>>

GO TO 2.

PERFORM VIN REGISTRATION

Refer to Work Procedure.

>>

GO TO 3.

WRITING MAC KEY FOR ECM

Refer to Work Procedure.

>>

GO TO 4.

PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNING

Refer to Work Procedure.

>>

GO TO 5.

PERFORM THROTTLE VALVE CLOSED POSITION LEARNING

Refer to Work Procedure.

>>

GO TO 6.

WASTEGATE VALVE CLOSED POSITION LEARNING

Refer to Work Procedure.

>>

GO TO 7.

ELECTRIC INTAKE VALVE TIMING CONTROL ACTUATOR REFERENCE POSITION LEARNING

Refer to Work Procedure.

>>

GO TO 8.

PERFORM IDLE AIR VOLUME LEARNING

Refer to Work Procedure.

>>

GO TO 9.

CHANGE ENGINE OIL

Change engine oil, then perform ENGINE OIL DATE RESET. Refer to Work Procedure.

>>

GO TO 10.

ERASE DTC

With CONSULT

  1. Ignition switch OFF and wait at least 10 seconds.

  2. Ignition switch ON.

  3. Ignition switch OFF and wait at least 10 seconds.

  4. Ignition switch ON.

  5. Check “Self diagnosis result” of “ECM”.

Is any DTC detected?

YES>>

Erase DTC.

NO>>

END