Engine
Engine Oil Data Reset
In this manual: Engine
4steps
~24min
2/5difficulty
Done 0 of 4
Description
The oil control system allows calculating the remaining distance to drive before oil change request. The engine oil data reset must be performed after engine oil is changed. (For details, refer to Work Procedure .)
Work Procedure
START
Ignition switch ON.
Check information display of the combination meter.
Is Distance to Engine Oil Change displayed?
YES>>GO TO 3.
NO>>GO TO 2.
SELECT OIL CONTROL SYSTEM MODE
Push the Display next switch and select oil control system mode.
>>GO TO 3.
RESET ENGINE OIL DATA
Press and hold the Display Next switch at least 1 second while Distance to Engine Oil Change is displayed.
Stop pressing the Display Next switch, and a few seconds later, check that the value of Distance to Engine Oil Change is reset.
END
Was this page helpful?