Engine

Precautions for Pop up Engine Hood

~1min read

PRECAUTIONS FOR POP UP ENGINE HOOD : Precautions

  • Before removal or installation of the pop-up engine hood and harness, always OFF the ignition switch, disconnect the battery negative terminal, and wait for 3 minutes or more. (To discharge the accumulated electricity in the control unit auxiliary power supply circuit)

  • Never use pneumatic or electric tools, etc., to remove or install components of the pop-up engine hood.

  • Never repair the harness for the pop-up engine hood with a solder. Also, always avoid contact or interference between the harness and other parts.

  • Never use an electric tester like a circuit tester, etc., when inspecting the pop-up engine hood circuit or other individual parts. (To prevent activation due to the low voltage of the tester)

  • Never allow foreign materials like a screwdriver, etc., to enter the pop-up engine hood harness connector. (To prevent activation due to static electricity)

  • The yellow harness connector is used with the pop-up engine hood actuator for identification purposes compared to other harnesses.