Front Door Assembly
Removal and Installation
REMOVAL
Remove front door check link mounting bolt of vehicle body side.
Disengage pawl
of front door harness connector, and then release lock release lever
according to numerical order 1→2 indicated by arrows as shown in figure and disconnect front door harness connector.

| : vehicle front |
Support front door assembly with a proper material to prevent it from falling.
Remove front door hinge mounting nuts, and then remove front door assembly.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
Inspection
Open and close front door. Check that front door hinge and front door check link rotation portion moves smoothly.
Check front door hinge rotating part for lubrication condition. Apply body grease if necessary.

| : Body grease |
Check front door check link rotating part for lubrication condition. Apply body grease if necessary.

| : Body grease |
Adjustment
FITTING ADJUSTMENT
Fitting Adjustment Standard Dimension

| Front fender assembly | Front door panel | Rear door panel | |||
| Front door sash molding | Body side outer | Front door hinge | |||
| Front door striker | TORX bolt | ||||
| : Always replace after every disassembly. | |||||
| : N·m (kg-m, ft-lb) | |||||
| : Body grease | |||||
Unit: mm [in]
| Portion | Standard | |||
|---|---|---|---|---|
| Front door panel – Front fender assembly | F | Clearance | 4.5 ± 1.0 [0.177 ± 0.039] |
|
| G | Surface height | 0.0 ± 1.0 [0.000 ± 0.039] |
||
| Front door panel – Rear door panel | H | Clearance | 4.5 ± 1.0 [0.177 ± 0.039] |
|
| I | Surface height | 0.0 ± 1.0 [0.000 ± 0.039] |
||
| Front door sash molding – Body side outer | J | Clearance | 7.3 ± 1.8 [0.287 ± 0.071] |
|
| K | Surface height | 0.6 ± 1.9 [0.024 ± 0.075] |
||
Check the clearance and surface height between front door and each part by visually and touching.
If the clearance and the surface height are out of specification, adjust them according to the procedures shown below.
Fitting Adjustment Procedure
Remove front door assembly. Refer to Removal and Installation.
Loosen front door hinge mounting bolts.
Temporary install front door panel, and then adjust the clearance of front door according to the fitting adjustment standard dimension by moving front door panel.
Remove temporary install parts, and then tighten front door hinge mounting bolts to the specified torque.
Install front door assembly, and then temporary tighten front door hinge mounting nuts. Refer to Removal and Installation.
Adjust the surface height of front door according to the fitting adjustment standard dimension by moving front door panel.
Tighten front door hinge mounting nuts to the specified torque.
FRONT DOOR STRIKER ADJUSTMENT
Adjust front door striker so that it becomes parallel with door lock insertion direction.