Body Exterior, Doors, Roof & Vehicle Security
Hood Stay
In this manual: Body Exterior, Doors, Roof & Vehicle Security
~1min read
Removal and Installation
REMOVAL
Support hood assembly with a suitable material to prevent it from falling.
Remove metal clip
located on connection between hood stay
and stud ball part
of hood assembly using a remover tool (A) according to the numerical order 1→2 indicated by arrows as shown in the figure.

Remove hood stay from hood assembly.
Repeat the same operation to disengage hood stay from stud ball, and then remove hood stay.
Loosen stud ball, and then remove stud ball from hood assembly.
INSTALLATION
Install in the reverse order of removal.
Disposal
Fix hood stay
using a vise (C).

Using hacksaw slowly make 2 holes in the hood stay, in numerical order as shown in the figure.

| A: | 20.0 mm (0.787 in) |
| Cut at the groove. |
Was this page helpful?