Rear Door Assembly
Removal and Installation
REMOVAL
Remove rear door harness grommet from vehicle body, and then pull out rear door harness and disconnect rear door harness connector.
Remove rear door check link mounting bolt of vehicle body side.
Support rear door assembly with a proper material to prevent it from falling.
Remove rear door hinge mounting nuts, and then remove rear door assembly.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
Inspection
Open and close rear door. Check that rear door hinge and rear door check link rotation portion moves smoothly.
Check rear door hinge rotating part for lubrication condition. Apply body grease if necessary.

| : Body grease |
Check rear door check link rotating part for lubrication condition. Apply body grease if necessary.

| : Body grease |
Adjustment
FITTING ADJUSTMENT
Fitting Adjustment Standard Dimension

| Front door panel | Rear door panel | Body side outer | |||
| Rear door sash molding | Rear door hinge | Rear door striker | |||
| TORX bolt | |||||
| : Always replace after every disassembly. | |||||
| : N·m (kg-m, ft-lb) | |||||
| : Body grease | |||||
Unit: mm [in]
| Portion | Standard | |||
|---|---|---|---|---|
| Front door panel – Rear door panel | F | Clearance | 4.5 ± 1.0 [0.177 ± 0.039] |
|
| G | Surface height | 0.0 ± 1.0 [0.000 ± 0.039] |
||
| Rear door panel – Body side outer | H | Clearance | 4.5 ± 1.0 [0.177 ± 0.039] |
|
| I | Surface height | 0.0 ± 1.0 [0.000 ± 0.039] |
||
| Rear door sash molding – Body side outer | J | Clearance | 7.3 ± 1.8 [0.287 ± 0.071] |
|
| K | Surface height | 1.0 ± 1.7 [0.039 ± 0.067] |
||
Check the clearance and surface height between rear door and each part by visually and touching.
If the clearance and the surface height are out of specification, adjust them according to the procedures shown below.
Fitting Adjustment Procedure
Loosen rear door hinge mounting nuts.
Adjust the surface height of rear door according to the fitting adjustment standard dimension by moving rear door panel.
Tighten rear door hinge mounting nuts to the specified torque.
Loosen rear door hinge mounting bolts.
Adjust the clearance of rear door according to the fitting adjustment standard dimension by moving rear door panel.
Tighten rear door hinge mounting bolts to the specified torque.
REAR DOOR STRIKER ADJUSTMENT
Adjust rear door striker so that it becomes parallel with door lock insertion direction.