P0725 engine speed
Description
The engine speed signal is transmitted from ECM to TCM by CAN communication line.
DTC Logic
DTC DETECTION LOGI

DTC CONFIRMATION PROCEDURE
CAUTION:Always drive vehicle at a safe speed. NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON. 2. Select “DATA MONITOR” in “TRANSMISSION”.
3. Start engine and maintain the following conditions for at least 10 consecutive seconds.
PRI SPEED SEN : More than 1000 rpmIs “P0725” detected? YES >> Go to TM-212, "Diagnosis Procedure".
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. CHECK DTC WITH ECM
With CONSULT-III
1. Turn ignition switch ON.
2. Select “SELF-DIAG RESULTS” in “ENGINE”.
Is the inspection result normal? YES >> GO TO 2.
NO >> Check the DTC detected item. Refer to EC-83, "CONSULT-III Function".
2. CHECK DTC WITH TCM
With CONSULT-III
Select “SELF-DIAG RESULTS” in “TRANSMISSION”.
Is the inspection result normal? YES >> GO TO 3.
NO >> Check the DTC detected item. Refer to TM-159, "CONSULT-III Function (TRANSMISSION)".
3. CHECK INPUT SIGNALS
With CONSULT-III
1. Start engine. 2. Select “DATA MONITOR” in “TRANSMISSION”.
3. While monitoring “ENG SPEED SIG”, check for engine speed change corresponding to “ACC PEDAL OPEN”.

Is the inspection result normal? YES >> GO TO 4.
NO >> Check ignition signal circuit. Refer to EC-414, "Component Function Check".
4. CHECK TCMCheck TCM input/output signals. Refer to TM-164, "Reference Value".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace the TCM. Refer to TM-280, "Removal and Installation".