P1723 speed sensor
Description
The secondary speed sensor detects the revolution of parking gear and generates a pulse signal. The pulse signal is sent to the TCM, which converts it into vehicle speed.
The prymary speed sensor detects the primary pulley revolution speed and sends a signal to the TCM.
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
CAUTION:Always drive vehicle at a safe speed. NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON. 2. Select “DATA MONITOR” in “TRANSMISSION”.
3. Start engine and maintain the following conditions for at least 5 consecutive seconds
VEHICLE SPEED : 10 km/h or more ACC PEDAL OPEN : More than 1.0/8 RANGE : “D” positionENG SPEED : 450 rpm or more Driving location : Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
Is “P1723” detected? YES >> Go to TM-244, "Diagnosis Procedure".
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1.CHECK STEP MOTOR FUNCTIONPerform the self-diagnosis check
Is a malfunction in the step motor function indicated in the results? YES >> Repair or replace damaged parts. (Check the step motor function. Refer to TM-252, "DTC Logic".) NO >> GO TO 2.
2.CHECK SECONDARY SPEED SENSOR SYSTEMCheck secondary speed sensor system. Refer to TM-209, "DTC Logic".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace damaged parts.
3.CHECK PRIMARY SPEED SENSOR SYSTEMCheck primary speed sensor system. Refer to TM-207, "DTC Logic".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace damaged parts.
4.CHECK ENGINE SPEED SIGNAL SYSTEMCheck engine speed signal system. Refer to TM-212, "DTC Logic".
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace damaged parts.
5.CHECK TCMCheck TCM input/output signals. Refer to TM-164, "Reference Value".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace TCM.