P0746 pressure control solenoid A
Description
The line pressure solenoid valve regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM.
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
CAUTION:Always drive vehicle at a safe speed. NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select “DATA MONITOR” in “TRANSMISSION” 3. Start engine and maintain the following conditions for at least 10 consecutive seconds. Test start from 0 km/h.
ATF TEMP SEN : 1.0 − 2.0 V ACC PEDAL OPEN : More than 1.0/8 RANGE : “D” positionVEHICLE SPEED : 10 km/h More than Driving location : Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
With GST
Follow the procedure “With CONSULT-III”.
Is “P0746” detected? YES >> Go to TM-221, "Diagnosis Procedure".
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1.CHECK LINE PRESSUREPerform line pressure test. Refer to TM-188, "Inspection and Judgment".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace damaged parts. Refer to TM-188, "Inspection and Judgment".
2.CHECK LINE PRESSURE SOLENOID VALVECheck line pressure solenoid valve. Refer to TM-220, "Component Inspection".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace damaged parts.
3.CHECK SECONDARY SPEED SENSOR SYSTEMCheck secondary speed sensor system. Refer to TM-209, "DTC Logic".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace damaged parts.
4.CHECK PRIMARY SPEED SENSOR SYSTEMCheck primary speed sensor system. Refer to TM-207, "DTC Logic".
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace damaged parts.
5.CHECK TCMCheck TCM input/output signals. Refer to TM-164, "Reference Value".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace the TCM. Refer to TM-280, "Removal and Installation".