P1777 step motor
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
CAUTION:Always drive vehicle at a safe speed. NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON. 2. Drive vehicle for at least 5 consecutive seconds.
3. Select “Self Diagnostic Results” in “TRANSMISSION”.
With GST
Follow the procedure “With CONSULT-III”.
Is “P1777” detected? YES >> Go to TM-250, "Diagnosis Procedure".
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1.CHECK INPUT SIGNALS
With CONSULT-III
1. Start engine. 2. Select “DATA MONITOR”.
3. Start vehicle and read out the value of “STM STEP”, “SMCOIL A”, “SMCOIL B”, “SMCOIL C”, and “SMCOIL D”.

Is the inspection result normal? YES >> GO TO 4.
NO >> GO TO 2.
2.CHECK HARNESS BETWEEN TCM AND STEP MOTOR 1. Turn ignition switch OFF. 2. Disconnect CVT unit harness connector and TCM connector.3. Check continuity between TCM connector terminals and CVT unit harness connector terminals.

4. If OK, check harness for short to ground and short to power. 5. If OK, check continuity between body ground and transaxle assembly.
6. Reinstall any part removed.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace damaged parts.
3.CHECK STEP MOTORCheck step motor. Refer to TM-251, "Component Inspection".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace damaged parts.
4.CHECK TCMCheck TCM input/output signals. Refer to TM-164, "Reference Value".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace the TCM. Refer to TM-280, "Removal and Installation".
Component Inspection
STEP MOTOR
1.STEP MOTOR 1. Turn ignition switch OFF. 2. Disconnect CVT unit harness connector.3. Check resistance between CVT unit harness connector terminals and ground.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace the transaxle assembly. Refer to TM-301, "Removal and Installation".