P0841 transmission fluid pressure SEN/SW A
Description
Using the engine load (throttle position), the primary pulley revolution speed, and the secondary pulley revolution speed as input signal, TCM changes the operating pressure of the primary pulley and the secondary pulley and changes the groove width of the pulley to control the gear ratio.
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
CAUTION:Always drive vehicle at a safe speed. NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.
Perform the following procedure to confirm the malfunction is eliminated after the repair.
1.CHECK DTC DETECTIONWith CONSULT-III
1. Turn ignition switch ON. 2. Select “DATA MONITOR” in “TRANSMISSION”.3. Start engine and maintain the following conditions for at least 12 consecutive seconds.
VEHICLE SPEED : 40 km/h More than RANGE : “D” positionIs “P0841” detected? YES >> Go to TM-232, "Diagnosis Procedure".
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1.CHECK LINE PRESSUREPerform line pressure test. Refer to TM-188, "Inspection and Judgment".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace damaged parts. Refer to TM-188, "Inspection and Judgment".
2.CHECK SECONDARY PRESSURE SENSOR SYSTEMCheck secondary pressure sensor system. Refer to TM-230, "DTC Logic".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace damaged parts.
3.CHECK LINE PRESSURE SOLENOID VALVECheck line pressure solenoid valve. Refer to TM-220, "Component Inspection".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace damaged parts.
4.CHECK SECONDARY PRESSURE SOLENOID VALVECheck secondary pressure solenoid valve. Refer to TM-226, "Component Inspection".
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace damaged parts.
5.CHECK STEP MOTORCheck step motor. Refer to TM-251, "Component Inspection".
Is the inspection result normal? YES >> GO TO 6.
NO >> Repair or replace damaged parts.
6.CHECK TCMCheck TCM input/output signals. Refer to TM-164, "Reference Value".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace the TCM. Refer to TM-280, "Removal and Installation".