P1722 vehicle speed
Description
The vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) to TCM by CAN communication line.
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
CAUTION:Always drive vehicle at a safe speed. NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON. 2. Select “DATA MONITOR” in “TRANSMISSION”.
3. Start engine and maintain the following conditions for at least 5 consecutive seconds.
ACC PEDAL OPEN : 1.0/8 or less VEHICLE SPEED : 30 km/h or moreIs “P1722” detected? YES >> Go to GI-42, "Intermittent Incident".
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)Perform “SELF-DIAG RESULTS”.
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace damaged parts.
2.CHECK INPUT SIGNALS
With CONSULT-III
1. Start engine.
2. Select “DATA MONITOR”.
3. Drive vehicle and read out the value of “VEHICLE SPEED” and “ESTM VSP SIG”.

4. Check if there is a great difference between the two values.
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> GO TO 3.
3.CHECK TCMCheck TCM input/output signals. Refer to TM-164, "Reference Value".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace TCM. Refer to TM-280, "Removal and Installation".