P0730 incorrect gear ratio
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON. 2. Wait at least 10 consecutive seconds.
3. Select “Self Diagnostic Results” in “TRANSMISSION”.
With GST
Follow the procedure “With CONSULT-III”.
Is “P0740” detected? YES >> Go to TM-215, "Diagnosis Procedure".
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. CHECK TORQUE CONVERTER CLUTCH SOLENOID VALVE CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect TCM connector.3. Check resistance between TCM connector terminal and ground.

Is the inspection result normal? YES >> GO TO 4.
NO >> GO TO 2.
2. CHECK HARNESS BETWEEN TCM AND TORQUE CONVERTER CLUTCH SOLENOID VALVE 1. Disconnect CVT unit harness connector.2. Check continuity between TCM connector terminal and CVT unit harness connector terminal.

3. If OK, check harness for short to ground and short to power. 4. If OK, check continuity between ground and transaxle assembly.
5. Reinstall any part removed.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace damaged parts.
3.CHECK TORQUE CONVERTER CLUTCH SOLENOID VALVECheck torque converter clutch solenoid valve. Refer to TM-216, "Component Inspection".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace damaged parts.
4.CHECK TCMCheck TCM input/output signals. Refer to TM-164, "Reference Value".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace the TCM. Refer to TM-280, "Removal and Installation".
Component Inspection
TORQUE CONVERTER CLUTCH SOLENOID VALVE
1.TORQUE CONVERTER CLUTCH SOLENOID VALVE 1. Turn ignition switch OFF. 2. Disconnect CVT unit harness connector.3. Check resistance between CVT unit harness connector terminal and ground.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace the transaxle assembly. Refer to TM-301, "Removal and Installation".