Transmission & Driveline

Calibration of G Sensor

6steps
~36min
3/5difficulty
Done 0 of 6
Description

TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of decel G sensor after the following work is performed.

  • Removal/installation or replacement of ABS actuator and electric unit (control unit)

  • Replacement of TCM

  • Erasing the calibration data of TCM

Refer to Work Procedure.

Work Procedure

PREPARATION BEFORE CALIBRATION PROCEDURE

  1. Park the Nissan Murano vehicle on a level surface.

  2. Adjust air pressure of all tires to the specified pressure. Refer to Tire Air Pressure.

>>

GO TO 2.

CONFIRM REPLACED PART

Was Decel G-Sensor removed or replaced?

YES>>

GO TO 3.

NO>>

GO TO 4.

PERFORM CALIBRATION OF DECEL G SENSOR (ABS)

Perform calibration of decel G sensor. Refer to Work Procedure.

>>

GO TO 4.

PERFORM CALIBRATION OF DECEL G SENSOR (TCM)

With CONSULT

  1. Turn ignition switch ON.

  2. Select “Work Support” in “TRANSMISSION”.

  3. Select “G SENSOR CALIBRATION”.

  4. Touch “Start”.

Is “COMPLETED” displayed?

YES>>

WORK END

NO>>

Perform steps 2 and 3 again.