Transmission & Driveline

Stall Test

~1min read
Work Procedure

INSPECTION

Check the engine oil level. Replenish if necessary. Refer to Inspection.

Check for leak of the CVT fluid. Refer to Inspection.

Drive for about 10 minutes to warm up the Nissan Murano vehicle so that the CVT fluid temperature is 50 to 80 °C.

Be sure to apply the parking brake and block the tires.

Start the engine, depress the brake pedal and put the selector lever to the D position.

While depressing the brake pedal, depress the accelerator pedal gradually.

Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.

Stall speed : Refer to Stall Speed.

Place the selector lever in the N position.

Cool the CVT fluid.

Put the selector lever to the R position and perform Step 6 to Step 9 again.

NARROWING-DOWN MALFUNCTIONING PARTS

Selector lever position Possible cause
D R
Stall speed H O
  • Forward clutch

O H
  • Reverse brake

L L
  • Engine

  • Torque converter one way clutch

H H
  • Line pressure is low.

  • Primary pulley

  • Secondary pulley

  • Chain belt

O: Within the stall speed standard value.

H: Stall speed is higher than the standard value.

L: Stall speed is lower than the standard value.