Cvt Fluid Cooler System

| Transaxle assembly | Hose clamp | CVT fluid cooler hose A | |||
| Hose clip | CVT fluid cooler hose B | Connector tube | |||
| CVT fluid cooler hose C | Oil warmer | ||||
| To radiator. Refer to Exploded View. | |||||
| : Always replace after every disassembly. | |||||
Always perform a CVT Fluid Cooler Flush after any one of the following:
CVT (transaxle) assembly overhaul, internal repair or replacement
Control valve replacement
Torque converter replacement
CVT FLUID COOLER CLEANING PROCEDURE
Remove front under cover. Refer to Removal and Installation.
Position an oil drain pan under the CVT fluid cooler.
Position an oil drain pan under the CVT oil warmer.
Disconnect the CVT fluid cooler hose A and CVT fluid cooler hose B from the CVT oil warmer. Refer to Exploded View.
Allow any transmission fluid that remains in the CVT fluid cooler hoses to drain into the oil drain pan.
Flush CVT fluid cooler and hoses using the following steps:Attach a suitable hose (A) to the CVT fluid cooler hose (1).

| Hose inside diameter | : 16mm (5/8 in) |
Attach a suitable hose over the end of the CVT fluid cooler hose (2) that was used as the flush inlet.

| Hose inside diameter | : 16mm (5/8 in) |
Blow compressed air through CVT fluid cooler hose (2) for 10 seconds to force remaining fluid out of CVT fluid cooler hose (1).
| Air pressure | : 490-883 kPa (5-9 kg/cm2, 70-128 psi) |
Repeat steps 6-8 one additional time, then proceed to step 10.
Reverse flush the CVT fluid cooler. Install Transmission Cooler Cleaner to CVT fluid cooler hose (1), then repeat steps 6-8 twice.
Install CVT fluid cooler hose A and CVT fluid cooler hose B to the CVT oil warmer. Refer to Exploded View.
Fill the transaxle assembly with CVT fluid. Refer to Replacement.