Rear lamps: replacing bulbs

Rear lamps

Rear lamps

Depending on vehicle, open the hinged doors or the tailgate.

Unscrew screws 1 using a Torx key.

Unclip the lower part, then the upper part of the lamp by pulling it towards you.

Pull tabs 2 to unclip bulb holders 3.

Replace the bulb, then reverse the procedure to refit the lamp.

Bulb types

4. Indicator lamp

Pear-shaped bulb with pins PY21W.

5. Position and stop lamp

Pear-shaped twin-filament bulb with pins P 21/5W.

6. Reversing lamp (right side, or both sides depending on vehicle) Pear-shaped bulb with pins P 21W.

Third stop lamp

Third stop lamp

• Tailgate version: it is located above the rear window, in the centre.
• Hinged door version: it is located above the rear window, on the left-hand door.

From inside, remove the two plastic plugs 7. Unclip the lamp using a screwdriver, pressing into the housing of the metal clips.

From outside, remove lamp 8.

Replace the bulb without disconnecting the wiring.

Bulb type: W16W

To refit, reverse the procedure.

Make sure the tabs are properly locked.

Number plate lamp

Unscrew the two screws 9 using a Torx key.

Release the lamp to access bulbs 10.

Bulb type: W5W.

Change the bulbs, then refit the lamp.