Specifications
F4R or K4J or K4M


- with coolant temperature above 80 °C and after the engine has stabilised at 2500 rpm for approximately 30 seconds
- compatible with unleaded IO 91
- for legal values, see the specifications by country
- At 2000 rpm, CO must not exceed 0.3 %

| Designation | Make - Type | Special notes |
| Injection ECU | SAGEM 3000 | Sequential multipoint ignition and injection ECU 128-pin ECU
|
| Fuel pump | - |
It is part of a "pump - gauge - filter" assembly that includes the pressure regulator Pressure: 3.5 +/- 0.06 bar |
| Ignition coils | SAGEM | Four coils Primary resistance: terminals 1 and 2 approx. 0.5 Ω Secondary resistance: terminal 1 and high-tension output: 10.5 +/- 1.5 kΩ 2-way connector:
|
| Injectors | SIEMENS - DEKA 4 | Twin-spray electromagnetic injector Resistance: 14.5 +/- 0.7 Ω at 20 °C 2-way connector:
|
| Intake manifold pressure sensor | SIEMENS - MAP03 | Piezoelectric type sensor Replace the seal each time it is removed. Accelerator pedal potentiometer 3-way connector:
|
| Firing order | - |
1-3-4-2 No. 1 on flywheel side |
| Diagnostic | Diagnostic tools | CLIP only |
| Accelerator pedal potentiometer | CTS | Dual-track potentiometer Resistances:
6-way connector:
|
| Knock sensor | SAGEM | Piezoelectric type sensor Tightening torque: 2 daN.m |
| Crankshaft position and engine speed sensor | SIEMENS | Variable reluctance type sensor Resistance: 200 to 270 Ω at 23 °C Tightening torque: 0.8 daN.m |
| Upstream and downstream oxygen sensors | BOSCH - LSF 4.2 | Sensor heating is cut off when the exhaust gas temperature exceeds 850 °C. Heater resistance: 9 Ω at 20 °C 4-way connector:
Engine warm:
|
| Fuel vapor purge solenoid valve | SAGEM | Resistance: 26 +/- 4 Ω at 23 °C 2-way connector:
|
| Intake air temperature sensor | JAEGER | Negative temperature coefficient thermistor (see previous table) |
| Coolant temperature sensor | JAEGER ELTH or SILEA | Negative temperature coefficient thermistor (see previous table) |
| Refrigerant sensor | TEXAS INSTRUMENTS | 3-way connector:
|
F4R or K4J or K4M
K4J
| Designation | Make - Type | Special notes |
| Throttle body | VDO Egas T Diameter 60 mm |
6-way connector
Motor resistance: approx. 1.6 Ω at 23 °C Potentiometer resistance; terminals 1 and 5: 1000 +/- 250 Ω |
F4R or K4M
| Designation | Make - Type | Special notes |
| Throttle body | VDO Egas 5 Diameter 57 mm |
Electronic DC motor with gears 6-way connector
Potentiometer resistance; terminals 2 and 6: 1000 +/- 250 Ω |
K4M
| Designation | Make - Type | Special notes |
| Camshaft phaser solenoid valve | DELPHI | It is controlled by duty cycle. Resistance: 7.2 +/- 0.5 Ω at 20 °C 2-way connector:
|
| Camshaft position sensor | SAGEM | Hall effect sensor 3-way connector:
|
F4R
| Designation | Make - Type | Special notes |
| Spark plug | CHAMPION RC 87 YCL |
Single-electrode spark plugs Gap: 0.90 +/- 0.05 mm Tightening torque: 2.5 to 3 daN.m |
| Camshaft phaser solenoid valve | AISIN | It is controlled on/off. Resistance: 7.2 +/- 0.5 Ω at 20 °C 2-way connector:
|
| Catalytic converter | EBERSPÄCHER | C175 |
K4J or K4M
| Designation | Make - Type | Special notes |
| Spark plug | EYQUEM RFN 58 LZ or CHAMPION RC 87 YCL | Single-electrode spark plugs Gap: 0.95 +/- 0.05 mm Tightening torque: 2.5 to 3 daN.m |
| Catalytic converter | EBERSPÄCHER | C150 |
Test yourself
A quick Renault Megane quiz: every answer comes with an explanation and a link to the manual page.