Renault Megane Quiz
Bodywork

Engine mount

In this manual: Bodywork
Engine and peripherals — 141Chassis — 79Chassis — 72Renault Mégane III Driver's Manual — 87Electrical equipment — 221Engine and peripherals — 47Electrical equipment — 80Transmission — 14Air conditioning — 30Bodywork — 115Trim and upholstery — 44General vehicle information — 27Air conditioning — 59General vehicle information — 16Transmission — 38Sealing and soundproofing — 7General vehicle information — 3
3steps
~18min
2/5difficulty
Done 0 of 3

Replacing this part is an additional operation to the fender side panel and fender reinforcement for a frontal impact, combined with the partial replacement of the front side member and wheel arch for a right-hand side impact only.

Information on related parts is covered in their respective sections (see contents).

Note: If the spot welds cannot be made with the spot welder, they may be replaced with plug welds.

For this operation, use of the straightening bench is essential.

REPLACEMENT PART CONTENTS

Assembled with:
Rear engine mount section
Rear engine mount reinforcement
Central engine mount section
M10 clinch nuts
M6-16 clinch screws

Support moteur

PARTS CONCERNED (thickness in mm):

  1. Rear engine mount section 1,5
  2. Rear engine mount reinforcement 2
  3. Central engine mount section 2

PART IN POSITION

Support moteur

Test yourself

A quick Renault Megane quiz: every answer comes with an explanation and a link to the manual page.