Toyota 4Runner Quiz
Audio / Visual / Telematics

Dcm Power Source Circuit

In this manual: Audio / Visual / Telematics
General — 25Audio / Visual / Telematics — 283Brake — 187Drivetrain — 204Power Source / Network — 79Steering — 76Suspension — 130Vehicle Exterior — 391Vehicle Interior — 693
~1min read
DESCRIPTION

This is the power source circuit to operate the DCM (Telematics Transceiver).

WIRING DIAGRAM
CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (DCM - BATTERY AND BODY GROUND)

(a) Disconnect the F39 DCM (Telematics Transceiver) connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

F39-4 (E) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) in the table below

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

F39-1 (+B) - F39-4 (E)

Always

11 to 14 V

F39-7 (IG2) - F39-4 (E)

Ignition switch ON

11 to 14 V

F39-8 (ACC) - F39-4 (E)

Ignition switch ACC

11 to 14 V
Text in Illustration

*a

Front view of wire harness connector

(to DCM [Telematics Transceiver])

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

Test yourself

A quick Toyota 4Runner quiz: every answer comes with an explanation and a link to the manual page.