Reverse Signal Circuit
The radio and display receiver assembly receives a reverse signal from the park/neutral position switch assembly.
WIRING DIAGRAM
PROCEDURE
CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
(a) Disconnect the G49 radio and display receiver assembly connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
G49-2 (REV) - Body ground |
Ignition switch ON Shift lever in R |
11 to 14 V |
G49-2 (REV) - Body ground |
Ignition switch ON Shift lever in any position other than R |
Below 1 V |
| OK | .gif) | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
|
.gif)
CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY)
(a) Disconnect the G49 radio and display receiver assembly connector.
(b) Disconnect the B42 park/neutral position switch assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
G49-2 (REV) - B42-1 (RL) |
Always |
Below 1 Ω |
G49-2 (REV) - Body ground |
Always |
10 kΩ or higher |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH ASSEMBLY - BATTERY)
(a) Disconnect the B42 park/neutral position switch assembly connector.
(b) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
 |
(c) Proceed to the next step based on the check result.
Result | Proceed to |
|---|---|
NG |
A |
OK (for A750E) |
B |
OK (for A750F) |
C |
| A | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
| B | | REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
| C | | REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Test yourself
A quick Toyota 4Runner quiz: every answer comes with an explanation and a link to the manual page.