Network Operation

Data List / Active Test

~3min read

DATA LIST / ACTIVE TEST

DATA LIST

HINT:

The Techstream Data List allows you to read the values or status of switches, sensors, actuators and other components without removing any parts. This non-intrusive check can be very useful, since intermittent conditions or signals can be identified before parts or wiring are moved. Reading the Data List during troubleshooting saves time in diagnosis.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not determine whether a part is faulty based only on these reference values.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menu items: Body Electrical / Main Body or Smart Key (w/ Smart Key System) / Data List.

(e) Read the Data List by following the instructions on the Techstream.

Body Electrical > Main Body > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

D-Door Motor Communication

Connection status between the driver's door power window regulator motor assembly and the main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not connected

A DTC is output when an error occurs in LIN communication.

P-Door Motor Communication

Connection status between the front passenger door power window regulator motor assembly and the main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not connected

A DTC is output when an error occurs in LIN communication.

RR-Door Motor Communication

Connection status between the rear RH door power window regulator motor assembly and the main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not connected

A DTC is output when an error occurs in LIN communication.

RL-Door Motor Communication

Connection status between the rear LH door power window regulator motor assembly and the main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not connected

A DTC is output when an error occurs in LIN communication.

Master SW Communication

Connection status between the multiplex network master switch assembly and the main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not connected

A DTC is output when an error occurs in LIN communication.

The Number of DTC

Number of DTCs

0 à 255

Number of Registered DTCs

-

Body Electrical > Smart Key > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

# Codes

Number of DTCs

0 à 255

Number of Registered DTCs

-