Door Lock

Registration

~3min read

REGISTRATION

PRECAUTION / NOTICE / HINT

HINT:

  • Register a new ID code when replacing the door control transmitter assembly or the tire pressure control system receiver/door control unit assembly.
  • Add mode retains the ID codes already registered when registering a new ID code. This mode is used when adding a door control transmitter assembly.
  • The re-registration mode is used to delete all codes already registered and to memorize new recognition codes. This mode is used when replacing the door control transmitter assembly or the door control and tire pressure monitoring receiver assembly with a new part.
  • The confirmation mode is used to check the number of recognition codes already registered before registering an additional code.
  • The prohibition mode is used to delete all registered codes and cancel the remote door lock function. Use this mode when the door control transmitter assembly is lost.
  • All steps of the following registration procedure must be performed in continuous sequential order.

PROCEDURE

1. REGISTER RECOGNITION CODE (USING TECHSTREAM)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menus: Body Electrical / Main Body / Utility / Wireless Code Registration.

Body Electrical > Main Body > Utility

Wireless Code Registration

(e) Select the add or re-registration mode according to the Techstream display.

(f) The number of registered codes is displayed.

(g) Register the door control transmitter assembly

(1) If the add or re-registration mode has been selected, press the lock and unlock switches on the door control transmitter assembly at the same time.

(2) Within 3 seconds after releasing the lock and unlock switches, press one of the switches on the door control transmitter assembly.

NOTICE:

  • Do not press the lock and unlock switches at the same time for more than 1.5 seconds.
  • Perform this operation within 1 meter of the driver's seat to register the door control transmitter assembly.
  • Do not press any other switches on the door control transmitter assembly during the door control transmitter assembly registration procedure.

(3) The main body ECU (multiplex network body ECU) automatically performs the power door lock/unlock operation to indicate whether registration was completed successfully or not.

(4) If registration continues, the next recognition code must be registered in the door control transmitter assembly within 30 seconds.

HINT:

A maximum of 4 recognition codes can be registered.

(h) Exit the registration mode.

(1) The registration mode ends in the following cases:

  • At least 30 seconds have elapsed after a code was registered.
  • Techstream is used to end registration.
  • Techstream is disconnected.
  • The ignition switch is turned to the OFF position.

(i) Perform the following instructions after registration is complete.

(1) Check the operation of the wireless power door lock.

Click here

HINT:

If the wireless power door lock does not operate, repeat the registration procedure.