Exterior Lighting

Headlight ECU

~2min read

Components

COMPONENTS

ILLUSTRATION

*1

HEADLIGHT ECU SUBASSEMBLY

*2

HEADLIGHT SEAL

●

Non-reusable part

-

-

Removal

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after the parts have been removed and installed or replaced during removal/installation of the left headlight ECU subassembly are listed below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

Left Headlight ECU Subassembly

  • Synchronize Vehicle Information
  • Initialize LH Headlight ECU Sub-assembly

Automatic Headlight Leveling System

NOTICE:

If the right headlight ECU subassembly is replaced with a new part, reinitialization and registration of vehicle information is not required.

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. REMOVE HEADLIGHT ASSEMBLY

Click here

2. REMOVE HEADLIGHT ECU SUBASSEMBLY

NOTICE:

Be sure to replace the headlight seal with a new one. Failure to do so may allow water to enter.

(a) Remove the 3 screws.

(b) Detach the connector cover from the headlight ECU subassembly.

(c) Disconnect the connector to remove the headlight ECU subassembly.

NOTICE:

If the headlight ECU subassembly has been subjected to an impact or dropped, replace it with a new one.

3. REMOVE HEADLIGHT SEAL

NOTICE:

Be sure to replace the headlight seal with a new one. Failure to do so may allow water to enter.

(a) Remove the headlight seal.

Installation

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL HEADLIGHT SEAL

(a) Install a new headlight seal.

2. INSTALL HEADLIGHT ECU SUBASSEMBLY

(a) Connect the connector.

(b) Install the connector cover onto the headlight ECU subassembly.

(c) Install the headlight ECU subassembly with the 3 screws.

NOTICE:

If the headlight ECU subassembly has been subjected to an impact or dropped, replace it with a new one.

3. INSTALL HEADLIGHT ASSEMBLY

Click here