Exterior Lighting

Headlight Level Control Switch

~2min read

Components

COMPONENTS

ILLUSTRATION

*1

HEADLIGHT LEVEL CONTROL SWITCH

*2

INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Removal

REMOVAL

PROCEDURE

1. REMOVE COMBINATION METER FINISH PANEL SUB-ASSEMBLY

Click here

2. REMOVE HEADLIGHT LEVEL CONTROL SWITCH

(a) Using a screwdriver with the tip wrapped in protective tape, release the claws to remove the headlight level control switch.

*a

Protective tape

Inspection

INSPECTION

PROCEDURE

1. INSPECT HEADLIGHT LEVEL CONTROL SWITCH

(a) Check voltage.

(1) Connect the positive (+) battery cable to terminal 1 (B) and the negative (-) battery cable to terminal 4 (E).

*a

Component without wire harness connected

(headlight level control switch)

(2) Measure the voltage according to the value(s) shown in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

2 (T) - 4 (E)

0

9,5 à 10,2 V

1

8,1 à 8,8 V

2

6,6 à 7,4 V

3

5,2 à 6,0 V

4

3,8 à 4,5 V

5

2,4 à 3,1 V

HINT:

  • Battery voltage is 12 V.
  • If the result is not as specified, replace the headlight level control switch.

(b) Check illumination.

(1) Apply battery voltage to the headlight level control switch and check that the indicator light comes on.

OK:

Condition

Specified Condition

Battery positive (+) → Terminal 3 (+) (ILL+)

Battery negative (-) → Terminal 4 (E)

Comes on

HINT:

If the result is not as specified, replace the headlight level control switch.

*a

Component without wire harness connected

(headlight level control switch)

Installation

INSTALLATION

PROCEDURE

1. INSTALL HEADLIGHT LEVEL CONTROL SWITCH

(a) Engage the claws to install the headlight level control switch.

2. INSTALL COMBINATION METER FINISH PANEL SUB-ASSEMBLY

Click here