Maintenance

Replacement

~3min read
0204060801004936N·mlb·ft
Tightening torque found on this page

REPLACEMENT

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during CVT fluid replacement are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Required Procedure

Effect/Inoperative function when procedure not performed

Link

CVT Fluid Replacement

ATF Thermal Degradation Estimate Reset

The value of the "ATF Thermal Degradation Estimate" Data List item is not estimated correctly.

PROCEDURE

1. REPLACE CONTINUOUSLY VARIABLE TRANSMISSION FLUID

(a) Raise the vehicle. [*1]

NOTICE:

Place the vehicle on a lift so that the vehicle is held level while raised (make sure that the inclination angle between the front and rear of the vehicle is within +/-1°).

(b) Remove the No. 1 engine under cover.

Click here

(c) Remove the rear left engine under cover.

Click here

(d) Remove the filler plug and gasket from the continuously variable transmission assembly. [*2]

(e) Using a 10 mm hexagon socket wrench, remove the drain plug and gasket from the transmission oil pan sub-assembly (CVT). [*3]

(f) Measure the amount of fluid drained. [*4]

HINT:

Add the same amount of fluid as in step [*6].

(g) Using a 10 mm hexagon socket wrench, temporarily install the gasket and drain plug to the transmission oil pan sub-assembly (CVT). [*5]

HINT:

Reuse the old gasket as the drain plug will need to be removed again when flushing the CVT fluid.

(h) Add fluid through the filler hole using the same amount of fluid as in step [*4]. [*6]

NOTICE:

Use genuine Toyota CVT FE fluid.

(i) Temporarily install the gasket and filler plug to the continuously variable transmission assembly. [*7]

HINT:

Reuse the old gasket as the filler plug will need to be removed again when flushing the CVT fluid.

(j) Lower the vehicle. [*8]

(k) Start the engine. [*9]

(l) Slowly move the shift lever from P to D, then back to P (hold the shift lever in each position for about 3 seconds). [*10]

HINT:

Slowly move the shift lever to circulate the fluid through each part of the continuously variable transmission assembly.

(m) Let the engine run at idle for 30 seconds to warm it up. [*11]

(n) Turn the ignition switch OFF. [*12]

(o) Repeat steps [*1] to [*12].

(p) Repeat steps [*1] to [*12].

(q) Using a 10 mm hexagon socket wrench, install a new gasket and the drain plug to the transmission oil pan sub-assembly (CVT).

Torque:

49 N·m {500 kgf·cm, 36 ft·lbf}

2. ADD SPECIFIED AMOUNT OF FLUID

Click here

3. ADJUST FLUID TEMPERATURE (when using Techstream)

Click here

4. ADJUST FLUID TEMPERATURE (without using Techstream)

Click here

5. ADJUST FLUID LEVEL

Click here

6. PERFORM ATF THERMAL DEGRADATION ESTIMATE RESET

NOTICE:

If approximately 50% or more of the CVT fluid has been replaced during transaxle repair or similar work, perform the ATF thermal degradation estimate reset.

Click here

7. REASSEMBLY

Click here