Replacement
REPLACEMENT
PRECAUTION / NOTICE / HINT
NOTICE:
- for manual transaxle:
Place the shift lever in neutral and apply the parking brake before bleeding the brakes.
- for CVT:
Place the shift lever in P and apply the parking brake before bleeding the brakes.
- Add brake fluid to keep the level between the MIN and MAX marks on the reservoir while bleeding the brakes.
- If brake fluid leaks onto a painted surface, wipe it off immediately.
HINT:
Before working on the brake system, or if air may be present in the brake lines, bleed the brake system.
PROCEDURE
1. REMOVE NO. 1 ROOF REGISTER CENTER GRILLE
(a) Release the hook and clip, and detach the seal between the hood and roof header from the roof register subassembly. |
|
(b) Release the 2 claws and 3 guides to remove the No. 1 roof register center grille from the roof register subassembly.
2. FILL BRAKE FLUID RESERVOIR
(a) Remove the filler hole cap from the brake master cylinder reservoir. |
![]() |
(b) Fill the brake fluid reservoir.
Brake fluid:
SAE J1703 or FMVSS No. 116 DOT 3
SAE J1704 or FMVSS No. 116 DOT 4
NOTICE:
- Do not remove the brake master cylinder reservoir filter, and be sure to fill the brake master cylinder reservoir with new brake fluid to prevent possible contamination of the brake system. Contamination, for example by dirt particles or mineral oil, may cause brake malfunctions.
- Make sure there is enough brake fluid in the reservoir.
3. BLEED BRAKE LINE
NOTICE:
- Bleed the brake line of the wheel farthest from the master cylinder first.
- Add brake fluid to keep the level between the MIN and MAX marks on the reservoir while bleeding the brakes.
(a) Connect a vinyl tube to the bleeder plug.
(b) Depress the brake pedal several times, then loosen the bleeder plug while keeping the pedal depressed.*1
(c) When brake fluid stops flowing, tighten the bleeder plug, then release the brake pedal.*2
(d) Repeat steps *1 and *2 until all air is purged from the brake fluid and fresh brake fluid flows out.
(e) Tighten the bleeder plug fully.
Torque:
Front brake:
7.5 N·m {76 kgf·cm, 66 in·lbf}
Rear brake (TMC manufactured):
8.3 N·m {85 kgf·cm, 73 in·lbf}
Rear brake (TMMT manufactured):
11 N·m {112 kgf·cm, 8 ft·lbf}
(f) Repeat the previous steps to replace the brake fluid in the brake lines for each wheel.
4. CHECK FOR BRAKE FLUID LEAKS
5. CHECK BRAKE FLUID LEVEL IN RESERVOIR
Click here![]()
6. INSTALL NO. 1 ROOF REGISTER CENTER GRILLE
(a) Engage the 2 claws and 3 guides to install the No. 1 roof register center grille on the roof register subassembly.
(b) Engage the clip and hook, and install the seal between the hood and roof header on the roof register subassembly.

