If problems arise

If the vehicle battery is discharged

4steps
~24min
2/5difficulty
Done 0 of 4

You can proceed as follows to start the engine even though the battery is completely discharged.

You can also contact a Toyota dealer, an authorized Toyota repairer, or any reliable repairer or qualified repair shop.

If you have a set of jumper cables and a second vehicle equipped with a 12 V battery, you can start your vehicle by proceeding as follows.

1. Vehicles equipped with an alarm: Make sure you have the key with you.

When connecting the jumper cables, depending on the situation, the alarm may sound and the doors may lock.

2. Open the hood.

Toyota CH-R. Mesures à prendre en cas d'urgence

3. Connect the jumper cables as follows:

Toyota CH-R. Mesures à prendre en cas d'urgence
  1. Connect one clamp of the positive cable to the positive (+) terminal of your vehicle's battery.
  2. Connect the other clamp of the positive cable to the positive (+) terminal of the second vehicle's battery.
  3. Connect one clamp of the negative cable to the negative (-) terminal of the second vehicle's battery.
  4. Connect the other clamp of the negative cable to a secure, unpainted metal point away from the battery and any moving parts, as shown in the illustration.

4. Start the engine of the second vehicle. Slightly increase the engine speed and maintain it for about 5 minutes to recharge your vehicle's battery.

5. Vehicles equipped with a smart entry & start system: Open and close one of your vehicle's doors with the engine start switch in the OFF position.

6. Vehicles without a smart entry & start system: Maintain the engine speed of the second vehicle, turn the anti-theft ignition switch to "ON", then start your vehicle's engine.

Vehicles equipped with a smart entry & start system: Maintain the engine speed of the second vehicle, set the engine start switch to START mode, then start your vehicle's engine.

7. As soon as the engine has started, disconnect the jumper cables in exactly the reverse order from the order in which they were connected.

Once the engine has started, have the vehicle inspected as soon as possible by a Toyota dealer, an authorized Toyota repairer, or any reliable repairer.

■ Starting the engine when the battery is discharged (vehicles equipped with a Multidrive transmission) The engine cannot be started by pushing the vehicle.

■ To prevent battery discharge

  • Turn off the headlights and audio system when the engine is stopped. (Vehicles equipped with a Stop & Start system: Except when the engine is stopped by the Stop & Start system.)
  • Turn off all non-essential electrical equipment when driving at low speed for an extended period (for example, in heavy traffic).

■ Charging the battery The battery gradually discharges its stored electricity even when the vehicle is not in use, due to natural discharge and the leakage current of certain electrical equipment. If the vehicle is parked for a long period, the battery may discharge and the engine may no longer start. (The battery is recharged automatically while the vehicle is being driven.)

■ When recharging or replacing the battery

  • Vehicles equipped with a smart entry & start system: In some cases, it may not be possible to unlock the doors using the smart entry & start system when the battery is discharged. Use the conventional key or the wireless remote control of the power door lock system to lock or unlock the doors.
  • Vehicles equipped with a smart entry & start system: Once the battery has been recharged, the engine may not start on the first attempt, but it will start normally on the second try. This is not a malfunction.
  • Vehicles equipped with a "hands-free" entry and start system: The mode the start switch is in is stored by the vehicle. If the battery is reconnected, the system returns to the mode it was in before the battery was disconnected. Before disconnecting the battery, set the start switch to OFF.

    If you are not sure which mode the start switch was in before the battery discharged, be particularly careful when reconnecting the battery.

  • Vehicles equipped with a Stop & Start system: For a few minutes after disconnecting or reconnecting the battery terminals, or for a few minutes after replacing the battery, the engine may not be automatically stopped by the Stop & Start system. This condition can last approximately 5 to 60 minutes.

■ When replacing the battery (vehicles equipped with a Stop & Start system) Use a battery designed for use with a Stop & Start system and equivalent to the original battery. If you use a battery that is not of the specified type, the Stop & Start system functions may be restricted to protect the battery.

In addition, the battery performance may deteriorate and it may no longer be possible to start the engine. For details, contact a Toyota dealer, an authorized Toyota repairer, or any reliable repairer.

WARNING

■ To prevent the risk of battery fire or explosion Observe the following precautions to prevent ignition of flammable gases that may escape from the battery:

  • Make sure each jumper cable is connected correctly to the battery terminals, and in such a way that it cannot accidentally contact anything other than the intended terminal.
  • Do not allow the other end of the jumper cable connected to the "+" terminal to contact any bare metal surface.
  • Make sure the "+" and "-" clamps of the jumper cables do not touch each other.

■ Battery precautions The battery contains toxic, corrosive, acidic electrolyte, and some of its parts contain lead or lead alloys. Observe the following precautions when handling the battery:

  • If you work on the battery, always wear protective eyewear and take care to avoid contact of the electrolyte (acid) with your skin, clothing, or the vehicle body.
  • Do not lean over the battery.
  • If electrolyte accidentally contacts your skin or eyes, flush the affected area thoroughly with clean water and consult a doctor.

    Moisten the affected area with a sponge or damp cloth until you receive medical care.

  • Always wash your hands after handling the battery holder, terminals, and other battery parts.
  • Do not allow children near the battery.

■ To prevent damage to the vehicle (vehicles equipped with a manual transmission) Do not try to start the vehicle by pushing or towing it, as the catalytic converter could overheat and cause a fire.

NOTE

■ When handling jumper cables When connecting jumper cables, make sure they do not get caught in the cooling fans or the engine accessory drive belt.