Symptom Table
SYMPTOM TROUBLESHOOTING TABLE
HINT:
- Use the table below to determine the cause of the symptoms. If several suspected areas are listed, the possible causes of the symptom are shown in order of probability in the "Suspected Area" column of the table. Check each symptom, verifying the suspected areas in the order listed. Replace parts if necessary.
- Check the fuses and relays associated with this system before checking the suspected areas listed below.
Symptom | Suspected Area | Link |
|---|---|---|
Only the driver's side door LOCK functions do not operate |
Front Door Lock Assembly LH with Motor |
|
Wire harness or connector |
- |
|
Instrument Panel Junction Block Assembly |
- |
|
Only the driver's side door UNLOCK functions do not operate |
Front Door Lock Assembly LH with Motor |
|
Wire harness or connector |
- |
|
Main body ECU (multiplex network body ECU) |
- |
|
Instrument Panel Junction Block Assembly |
- |
|
Only the front passenger door lock/unlock functions do not operate |
Front door lock assembly RH with motor |
|
Wire harness or connector |
- |
|
Instrument Panel Junction Block Assembly |
- |
|
Only the rear left door LOCK/UNLOCK functions do not operate. |
Rear left door lock assembly with motor |
|
Wire harness or connector |
- |
|
Instrument Panel Junction Block Assembly |
- |
|
Only the rear right door LOCK/UNLOCK functions do not operate. |
Rear right door lock assembly with motor |
|
Wire harness or connector |
- |
|
Instrument Panel Junction Block Assembly |
- |
|
Only the back door opening function does not operate. |
Go to the "Only Back Door Opening Is Not Possible" procedure |
|
All door lock/unlock functions do not operate using the door control switch or door key cylinder |
Follow the "All Door LOCK/UNLOCK Functions Cannot Be Performed Using the Door Control Switch or Door Key Cylinder" procedure |
|
All door LOCK/UNLOCK functions cannot be operated using the door control switch |
Follow the "All Door LOCK/UNLOCK Functions Cannot Be Performed Using the Door Control Switch" procedure |
|
All door LOCK/UNLOCK functions cannot be performed using either the multiplex network master switch assembly or the door key cylinder. |
Instrument Panel Junction Block Assembly |
- |
Main body ECU (multiplex network body ECU) |
- |
|
Double lock function does not operate correctly*2 |
LIN Communication System |
|
Front Door Lock Assembly LH with Motor |
||
Front door lock assembly RH with motor |
||
Rear left door lock assembly with motor |
||
Rear right door lock assembly with motor |
||
Wire harness or connector |
- |
|
Double Locking Door Control Relay Assembly |
- |
|
Main body ECU (multiplex network body ECU) |
- |
|
Locking operation continues even after the doors are locked*1 |
Front Door Lock Assembly LH with Motor |
|
Front door lock assembly RH with motor |
||
Rear left door lock assembly with motor |
||
Rear right door lock assembly with motor |
||
Wire harness or connector |
- |
|
Instrument Panel Junction Block Assembly |
- |
|
Main body ECU (multiplex network body ECU) |
- |
|
When you return to the vehicle, the doors were unlocked even though no door unlock operation was performed. |
Go to the "Malfunction Operation" procedure |
|
When you return to the vehicle, the doors were locked even though no door lock operation was performed. |
Go to the "Malfunction Operation" procedure |
HINT:
- *1: If the door unlock detection switch detects an unlock position signal after a door lock operation has been performed, the door lock operation is repeated 3 times.
- *2: without Toyota Safety Sense P system
.gif)