Toyota Camry Quiz
Heater & air conditioner

V (cooler compressor to crankshaft pulley) beltNNo.1

In this manual: Heater & air conditioner
Introduction — 61Audio & visual system — 16Automatic transmission / trans — 19Transmission revolution (ATM) — 1Shift lock system (ATM) — 1Brake — 20Clutch — 10Communication system — 4Cooling — 15Cruise control — 3Drive shaft / propeller shaft — 9Emission control — 8Engine control system — 12Engine hood/door — 7Exhaust — 3Exterior/interior trim — 14Front suspension — 9Fuel — 12Heater & air conditioner — 16Ignition — 8Instrument panel/meter — 7Intake — 7Lighting — 11Lubrication — 16Manual transmission/transaxle — 13Parking brake — 10Power steering — 7Rear suspension — 10Seat — 12Service specifications — 26Sliding roof/convertible — 4Starting & charging — 11Starting system (2AZ−FE)(From July, 2003) — 1Starting system (1MZ−FE/3MZ−FE) — 1Steering column — 6Theft deterrent & door lock — 9Tire & wheel — 4Windshield/windowglass/mirror — 5Back window glass — 1Power window control system — 1Power mirror control system — 1Inner rear view mirror assy — 1Windshield glass — 1Wiring — 1
5steps
~30min
2/5difficulty
0102030405017.513N·mlb·ft
Tightening torque found on this page
Done 0 of 5
REPLACEMENT 1. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT No.1
  1. Loosen the bolt C.
  2. Loosen the bolt A.
  3. Loosen the bolt B and remove the cooler V belt No. 1.
Remove V (cooler compressor to crankshaft pulley) belt No.1 Remove V (cooler compressor to crankshaft pulley) belt No.1 2. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT No.1

a. Temporarily install the cooler V belt No. 1 as illustrated.

Install V (cooler compressor to crankshaft pulley) belt No.1 Install V (cooler compressor to crankshaft pulley) belt No.1 3. ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT No.1 a. Apply drive belt tension by turning the bolt B.Drive belt tension: New Belt: 165 27 lbf
Used belt: 88 22 lbf
HINT:

HINT:

  • ”New belt” refers to a belt which has been used less than 5 minutes on a running engine.
  • ”Used belt” refers to a belt which has been used on a running engine for 5 minutes or more.
  • After installing the drive belt, check that it fits properly in the ribbed grooves.
  • Check that the drive belt fits properly in the ribbed grooves.
4. FULLY TIGHTEN V (COOLER COMPRESSOR TO
4. FULLY TIGHTEN V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT No.1
  1. Tighten the bolt A. Torque: 17,5 N·m
  2. Tighten the bolt C. Torque: 58 N·m
Fully tighten V (cooler compressor to crankshaft pulley) belt No.1 Fully tighten V (cooler compressor to crankshaft pulley) belt No.1

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.