Toyota Land Cruiser Quiz
Body Electrical

Installation

In this manual: Body Electrical
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read
0102030405017.513N·mlb·ft
Tightening torque found on this page

NOTICE:

  • Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
  • Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
  • Never repair a sensor in order to reuse it.

HINT: For step 2 to 6, refer to page BO-91 .

1. INSTALL AIRBAG SENSOR ASSEMBLY

INSTALL AIRBAG SENSOR ASSEMBLY

(a) Install the airbag sensor assembly with the 3 bolts.

Torque: 17,5 N·m

(b) Connect the airbag sensor connectors.

NOTICE:

  • Connection of the connector is done after the sensor assembly has been installed.
  • Make sure the sensor assembly is installed with the specified torque.
  • If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
  • When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
  • After installing, shake the sensor assembly to check that there is no looseness.

2. INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

3. INSTALL FRONT CONSOLE BOX

4. INSTALL REAR CONSOLE BOX WITH CONSOLE REAR END PANEL

5. INSTALL UPPER CONSOLE PANEL

6. INSTALL TRANSFER SHIFT LEVER KNOB

7. INSTALL FRONT SEAT (BO-1 17)

8. INSPECT SRS WARNING LIGHT (DI-692 )

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.