Toyota Land Cruiser Quiz
Body Electrical

Installation

In this manual: Body Electrical
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read
010203040509.87N·mlb·ft
Tightening torque found on this page

NOTICE: Never use airbag parts from another vehicle. When replacing parts, replace them with new parts.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

(a) In the order shown in the illustration, install the curtain shield airbag with the 8 bolts.

Torque: 9,8 N·m

CAUTION: Pay due attention not to twist the deployment section of the curtain shield airbag assembly.

NOTICE:

  • Make sure that the curtain shield airbag assembly is installed to the specified torque.
  • If the curtain shield airbag assembly has been dropped, or there are cracks, dents or other defects in the case or connector, replace the curtain shield airbag assembly with a new one.
  • When installing the curtain shield airbag assembly, take care it is not pinched between other parts.

(b) Connect the connector of the curtain shield airbag assembly.

2. INSTALL ROOF HEADLINING (BO-101 )

3. INSPECT SRS WARNING LIGHT (DI-692 )

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.