Toyota Land Cruiser Quiz
Body Electrical

Removal

In this manual: Body Electrical
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read

NOTICE:

  • If the wiring connector of the SRS is disconnected and the ignition switch is at ON position, DTCs will be recorded.
  • Never use the airbag parts from another vehicle.

    When replacing parts, replace them with new parts.

1. REMOVE ROOF HEADLINING (BO-97 )

2. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

(a) Disconnect the curtain shield airbag connector.

NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

(b) In the order shown in the illustration, remove the bolts and curtain shield airbag assembly.

HINT:

  • Loosen the bolt (3) before removing the bolt (2).
  • Bind the front and rear parts of the curtain shield airbag assembly before removing the bolt (3).
REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

(c) Put the removed curtain shield airbag in a clear plastic bag and keep it in a safe place.

CAUTION: Never disassemble the curtain shield airbag assembly.

NOTICE: Plastic bag is not reusable.

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.