Toyota Land Cruiser Quiz
Body Electrical

Installation

In this manual: Body Electrical
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read
0102030405017.513N·mlb·ft
Tightening torque found on this page

NOTICE:

  • Never use SRS parts from another vehicle. When replacing parts, replace them with new ones.
  • Never reuse the curtain shield airbag sensor assembly involved in a collision when the airbag has deployed.
  • Never repair a sensor in order to reuse it.

HINT: For step 2 to 8, refer to page BO-101 .

1. INSTALL CURTAIN SHIELD AIRBAG SENSOR ASSEMBLY

INSTALL CURTAIN SHIELD AIRBAG SENSOR ASSEMBLY

(a) Install the curtain shield airbag sensor assembly with the 2 bolts.

Torque: 17,5 N·m

(b) Connect the connector.

NOTICE:

  • Connection of the connector is done after the sensor assembly has been installed.
  • Make sure that the sensor assembly is installed with the specified torque.
  • If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
  • When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
  • After installation, shake the sensor assembly to check that there is no looseness.

2. INSTALL QUARTER TRIM PANEL

3. INSTALL STRIKER PLATES

4. INSTALL REAR NO. 2 SEAT

5. INSTALL REAR MAT SET PLATE

6. INSTALL REAR SEAT BELT ANCHOR

7. INSTALL REAR DOOR OPENING TRIM

8. INSTALL REAR DOOR SCUFF PLATE

9. INSPECT SRS WARNING LIGHT (DI-692 )

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.