Toyota Land Cruiser Quiz
Body Electrical

Removal

In this manual: Body Electrical
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read

NOTICE:

  • Do not open the cover or the case of the ECU and various electrical devices unless absolutely necessary.

    (If the IC terminals are touched, the IC may be destroyed by static electricity.)

  • If the wiring connector of the SRS is disconnected and the ignition switch is at ON position, DTCs will be recorded.

HINT: For the step 1 to 7, refer to page BO-97 .

1. REMOVE REAR DOOR SCUFF PLATE

2. REMOVE REAR DOOR OPENING TRIM

3. REMOVE REAR SEAT BELT ANCHOR

4. REMOVE REAR MAT SET PLATE

5. REMOVE REAR NO. 2 SEAT

6. REMOVE STRIKER PLATES

7. REMOVE QUARTER TRIM PANEL

8. REMOVE CURTAIN SHIELD AIRBAG SENSOR ASSEMBLY

REMOVE CURTAIN SHIELD AIRBAG SENSOR ASSEMBLY

(a) Disconnect the connector.

NOTICE: Disconnect the connector with the sensor assembly installed.

(b) Remove the 2 bolts and curtain shield airbag sensor assembly.

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.