Removal

1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM

HINT: At the time of installation, first evacuate air from refrigeration system.

Then, charge the system with the refrigerant and inspect for leaks of the refrigerant.

Specified amount: 1,050 +- 50 g (37.03 +- 1.76 oz.)

2. DISCONNECT LIQUID AND SUCTION TUBES

(a) Using SST, remove the 2 piping clamps.

SST 09870-00025 (Liquid tube) 09870-00015 (Suction tube)

1. Insert SST to piping clamp.

HINT: Confirm the direction of the piping clamp claw and SST referring to the illustration on the caution label.

2. Push down SST and release the clamp lock.

NOTICE: Be careful not to deform the tubes when pushing SST.

1. 1
   Pull SST slightly and push the release lever, then remove the piping clamp with SST.
2. 2
   Remove the piping clamp from SST.

(b) Disconnect the both tubes.

NOTICE: Cap the open fittings immediately to keep moisture or dirt out of the system.

HINT: At the time of installation:

• Lubricate 4 new O-rings with compressor oil and install them to the tubes.
• After connection, check the fitting for claw of the piping clamp.

3. REMOVE INSTRUMENT PANEL AND REINFORCEMENT (BO-84 )

4. REMOVE ANTENNA RELAY

(a) Disconnect the connector.

(b) Remove the 2 screws and antenna relay.

5. REMOVE COOLING UNIT

(a) Disconnect the connector.

(b) Remove the 4 screws, 2 nuts and cooling unit.