Toyota Land Cruiser Quiz
Body Electrical

Disassembly

In this manual: Body Electrical
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read
010203040503.43N·mlb·ft
Tightening torque found on this page

1. REMOVE EVAPORATOR

REMOVE EVAPORATOR

(a) Disconnect the connector clamp.

(b) Remove the 8 screws and No. 1 cooler cover.

(c) Pull out the evaporator

HINT: At the time of reassembly, if evaporator is replaced, add compressor oil to the evaporator.

Add: 40 cc (1.4 fl.oz.)

Compressor oil: ND-OIL 8 or equivalent

2. PULL OUT EVAPORATOR TEMPERATURE SENSOR FROM EVAPORATOR

PULL OUT EVAPORATOR TEMPERATURE SENSOR FROM EVAPORATOR

3. REMOVE EXPANSION VALVE

REMOVE EXPANSION VALVE

(a) Remove the grommet.

(b) Pry out the packing.

HINT: At the time of reassembly, do not reuse the packing.

(c) Using a hexagon wrench (5.0 mm, 0.20 in.), remove the 2 bolts and separate the expansion valve, tube and evaporator.

Torque: 3,4 N·m

NOTICE: Cap the open fittings immediately to keep moisture or dirt out of the system.

HINT: At the time of reassembly, lubricate 4 new O-rings with compressor oil and install them in the tube.

4. REMOVE DRAIN HOSE

INSTALLATION

Installation is in the reverse of removal (AC-24 ).

REASSEMBLY

Reassembly is in the reverse of disassembly (AC-26 ).

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.