Footwell light circuit

The main body ecu receives information regarding the door lock position switch and ignition switch, and turns on each foot light.

1. 1
   Perform active test by intelligent tester (main body ecu)
2. 2
   Connect the intelligent tester (with can vim) to the dlc3.
3. 3
   Turn the ignition switch to the on position and press the intelligent tester main switch on
4. 4
   Select the items below in the active test and then check the relay operation.

   

1. 1
   Inspect fuse (dome)
2. 2
   Remove the dome fuse from the engine room no. 2 Relay block.
3. 3
   Measure the resistance of the fuse.

Standard resistance: below 1

1. 1
   Inspect foot light
2. 2
   Remove the foot light.
3. 3
   Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, then check that the light comes on.

4. Check wire harness (battery - main body ecu)

1. 1
   Install the foot light.
2. 2
   Disconnect the e15 main body ecu connector.
3. 3
   Measure the voltage of the wire harness side connector.

Standard voltage