Lighting
Front fog light circuit
In this manual: Lighting
25steps
~150min
4/5difficulty
Done 0 of 25
Description

Inspection procedure
Ok: front fog light comes on.













Replace instrument panel junction block (main body ecu)



Repair or replace harness and connector (headlight dimmer switch - body ground)
The main body ecu controls the front fog light relay (marking: fr fog) when a signal is received from the headlight dimmer switch.
Wiring diagram
Inspection procedure
- Perform active test by intelligent tester
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch to the on position and press the intelligent tester main switch on.
- Select the item below in the active test and then check the relay operation.

Ok: front fog light comes on.

- Check taillight
- Check that the taillight comes on when the light control switch is on (tail).

- Inspect fuse (fr fog)
- Remove the fr fog fuse from the instrument panel junction block.
- Measure the resistance of the fuses.

- Inspect fog light bulb

- Remove the fog light bulb.
- Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, then check that the bulb illuminates.

- Inspect front fog light relay (marking: fr fog)

- Remove the front fog light relay from the no. 6 Relay block.
- Measure the resistance of the relay.

- Check wire harness (battery - main body ecu)

- Disconnect the e17 ecu connector.
- Measure the voltage of the wire harness side connector.

- Check wire harness (front fog light relay - battery)

- Remove the front fog light relay from the no. 6 Relay block.
- Measure the voltage of the relay block.

- Check wire harness (front fog light relay - front fog light and body ground)

- Remove the front fog light relay from the no. 6 Relay block.
- Disconnect the a11 and a28 front fog light connectors.
- Measure the resistance of the wire harness side connectors.

Replace instrument panel junction block (main body ecu)
- Check wire harness (dimmer switch - main body ecu and body ground)

- Disconnect the e12 headlight dimmer switch connector.
- Disconnect the e17 main body ecu connector.
- Measure the resistance of the wire harness side connectors.

- Inspect fog light switch

- Remove the headlight dimmer switch.
- Measure the resistance of the switch.

Repair or replace harness and connector (headlight dimmer switch - body ground)
Test yourself
A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?