Audio / visual

Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

2steps
~12min
1/5difficulty
Done 0 of 2

DESCRIPTION

The stereo jack adapter sends an external device sound signal to the radio receiver through this circuit.

The sound signal that has been sent is amplified by the stereo component amplifier or radio receiver, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, radio receiver, or speakers.

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER)

CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER)
  1. Disconnect the connectors from the stereo jack adapter and radio receiver.
  2. Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

*1: 10 Speaker System
*2: 6 Speaker with Rear Entertainment System
*3: 6 Speaker without Rear Entertainment System

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.