Lighting
Inspection
In this manual: Lighting
~1min read
INSPECTION PROCEDURE
1. INSPECT AUTO HIGH BEAM SWITCH
*a |
Component without harness connected (Auto High Beam Switch) |
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| If the result is not as specified, replace the auto high beam switch. | ||
4 (+B) - 1 (E) |
Auto high beam switch ON |
Below 1 Ω |
Auto high beam switch OFF |
10 kΩ or higher |
|
(b) Check the illumination. (1) Apply battery voltage to the connector and check the illumination condition. OK:
|
|
||||||||||
Test yourself
A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?
