Audio, Visual, Telematics

Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

~1min read

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)

(a) Disconnect the J116 navigation receiver assembly connector.

(b) Disconnect the J100 No. 1 stereo jack adapter assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

J116-2 (US1-) - J100-2 (UDO-)

Always

Below 1 Ω

J116-3 (US1+) - J100-3 (UDO+)

Always

Below 1 Ω

J116-2 (US1-) - Body ground

Always

10 kΩ or higher

J116-3 (US1+) - Body ground

Always

10 kΩ or higher

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR