PROCEDURE
CHECK IF RADIO AUTO-SEARCH FUNCTIONS PROPERLY
(a) Check the radio automatic station search function by activating it.
OK:
Automatic station search function stops on a station.
| OK |
 |
USE SIMULATION METHOD TO CHECK |
| NG |
 |
|
CHECK OPTIONAL COMPONENTS
(a) Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
OK:
Optional components are installed.
NOTICE:
Do not remove optional components without permission of the customer.
| OK |
 |
REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE) |
| NG |
 |
|
CHECK RADIO ANTENNA
(a) Remove the pull top antenna pole sub-assembly from the fender antenna assembly.
(b) Place the tip of a screwdriver on the antenna and check that noise is heard from the speakers.
OK:
Noise occurs. Result
Result | Proceed to |
OK (for Column Shift Type) |
A |
OK (for Floor Shift Type) |
B |
NG |
C |
| A |
 |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
| B |
 |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
| C |
 |
|
CHECK NAVIGATION RECEIVER ASSEMBLY (ANTENNA)
(a) Remove the antenna connector from the navigation receiver assembly. |
 |
(b) Turn the ignition switch to ACC with the navigation receiver assembly connector connected.
(c) Turn on the radio and turn into AM mode.
(d) Place a screwdriver, thin wire or other metal object on the navigation receiver assembly antenna jack and check that noise can be heard from the speakers.
OK:
Noise occurs. Result
Result | Proceed to |
OK |
A |
NG (for Column Shift Type) |
B |
NG (for Floor Shift Type) |
C |
| B |
 |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
| C |
 |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
| A |
 |
|
INSPECT NAVIGATION RECEIVER ASSEMBLY
(a) Disconnect the J151 navigation receiver assembly connector. |
 |
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
5 (ANT+) - Body ground |
Ignition switch ACC, radio switch on and FM or AM selected |
11 to 14 V |
Result
Result | Proceed to |
OK |
A |
NG (for Column Shift Type) |
B |
NG (for Floor Shift Type) |
C |
| B |
 |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
| C |
 |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
| A |
 |
|
CHECK PULL TOP ANTENNA POLE SUB-ASSEMBLY
(a) Check that the pull top antenna pole sub-assembly is securely installed (See page ).
OK:
The pull top antenna pole sub-assembly is installed properly.
| NG |
 |
REINSTALL PULL TOP ANTENNA POLE SUB-ASSEMBLY |
| OK |
 |
|
CHECK FENDER ANTENNA ASSEMBLY
(a) Replace the fender antenna assembly and check if radio broadcasts can be received normally (See page ).
OK:
Radio broadcasts can be received normally. Result
Result | Proceed to |
OK |
A |
NG (for Column Shift Type) |
B |
NG (for Floor Shift Type) |
C |
| A |
 |
END (FENDER ANTENNA ASSEMBLY IS DEFECTIVE) |
| B |
 |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
| C |
 |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
|